Description: The Octava PRO DSX AV over IP transmitters and receivers should be configured individually to unique IP address with 172.31.xx.xx and Subnet of 255.255.0.0 . The Cisco network switch provided along with your PRO DSX system has been configured in order to work with the AV over IP system and your existing network.
A static route must be established for the Octava Control software to communicate with the PRO DSX AV over IP in the 172.31.xx address space as well as allowing your control device ( iPad, PC) to access other network devices and internet. There are 2 methods to establish static routes:
Method 1:Setting static route in router (preferred method) if your router supports Static Routing.
Method 2: Setting static route in the control device interface ( iPad, PC and etc)
System Diagram

Method 1: Static Route Setting on a ROUTER
Step 1: Log in to your LAN Router and determine the IP address of the Octava Controller and the Cisco Network Switch
Step 2 : Go to “Routing” and add a static route as shown below:
Set Default Gateway = IP address of your Cisco Switch from Step 1 (e.g., 192.168.0.130)
Step 3: Select DHCP Server → Go to Address Reservation
Reserve the IP addresses for the Octava Controller and the Cisco Switch.
This ensures the IP addresses will not be changed by the Router
Step 4. Accessing the Octava Controller
-
- Connect your iPad or PC to the same LAN Router WIFI network
-
- Open browser and entering the IP address of the Octava Controller followed by :3000

————————————————————————————————————————————————————————————
Method 2: Setting Static Route on iPad
Step 1:. Log in to your LAN Router and determine the IP address of the Octava Controller, the Cisco Network Switch and the iPad
Step 2 Open the Wi-Fi Network settings on the iPad
Step 3. Change the IP settings to:
Configure IP = Manual (or Static)
IP Address = IP address of the iPad from Step 1 (e.g., 192.168.0.26)
Subnet Mask = same as assigned by router
Router = IP address of the Cisco Switch from Step 1 (e.g., 192.168.0.130)
Step 4: Tap Configure DNS, select Manual, and set DNS to 8.8.8.8

Step 5. Select DHCP Server → Go to Address Reservation.
Reserve the IP addresses for the iPad, Cisco Switch, and Octava Controller so they will not be changed by the Router.
Step 6. Accessing the Octava Controller
-
- Connect your iPad to the same LAN Router WIFI network
-
- Open browser and entering the IP address of the Octava Controller followed by :3000
